User's Manual
Table Of Contents
- Tait Contact Information
- Contents
- Preface
- 1 System Specifications
- Transmit Power and Current Consumption - 240VAC Input
- Transmit Power and Current Consumption - 110VAC Input
- Transmit Power and Current Consumption - AC Input Voltage Extremes
- Transmit Power and Current Consumption - 12.5VDC Input
- Transmit Power and Current Consumption - DC Input Voltage Extremes
- Receive Power and Current Consumption
- Dimensions and Weight
- Isolation
- 2 Reciter Specifications
- General
- Receiver RF Section
- Receiver Audio Section - General
- Receiver Audio Section - CTCSS
- Receiver Audio Section - Gating Operation
- Exciter RF Section
- Exciter Audio Section - Inputs
- Exciter Audio Section - Modulation Characteristics
- Exciter Audio Section - CTCSS
- External Reference Input
- Compliance Standards
- 3 Power Amplifier and Transmitter Specifications
- 4 Power Management Unit Specifications
86 Connection TB8100 Installation and Operation Manual
© Tait Electronics Ltd March 2004
7.2 Power Supply Connections
AC Power The TB8100 PMU is designed to accept a mains input of 88 to 264VAC at
45 to 65Hz. We recommend that a standard 3-wire grounded outlet is used
to supply the AC power. The socket-outlet must be installed near the
equipment and must be easily accessible. This outlet should be connected
to an AC power supply capable of providing a maximum of 600W. The
requirements of two typical AC supplies are given in the following table.
Your TB8100 BSS should come supplied
with a power supply cord to connect the
male IEC connector on the PMU to the
local AC supply. The pins of the IEC
connector on the PMU are identified at
right.
DC Power The TB8100 PMU is designed to accept a DC input of 10.3 to 15.5VDC
with negative or positive ground. There is a minimum DC start-up
threshold to prevent damaging a battery which has little capacity left.
You must connect the DC supply from the battery to the PMU via a fuse or
DC-rated circuit breaker with a rating of 60A. The DC input leads should
be of a suitable gauge to ensure less than 0.2V drop at maximum load over
the required length of lead.
Figure 7.5 Power Save Control Panel Outputs
b
DC outputs for fans mounted on front panel;
also used for fan rotation detectors (if fitted)
c
RS-232 programming port
b
c
Nominal Supply Current Requirement
Circuit Breaker/Fuse
Rating
115VAC 8A 10A
230VAC 4A 6A
phase
neutral
ground
rear view