User's Manual
Table Of Contents
- Specifications Manual
- Tait Contact Information
- Contents
- Preface
- 1 System Specifications
- Supply
- Power Consumption @ 13.8 VDC
- Power Consumption Band B1, 25 W*
- Power Consumption Band B1, 50 W*
- Power Consumption Band H5, 25 W*
- Power Consumption Band H5, 40 W*
- Power Consumption Band H6, 25 W*
- Power Consumption Band H7, 40 W*
- Transmitting into 5:1 VSWR*
- Channel Data
- Environmental
- Physical
- Isolation
- RF Compliance
- EMC Compliance
- Environmental Compliance
- Safety Compliance
- General
- 2 Receiver Specifications
- 3 Transmitter Specifications
20 Receiver Specifications TB7100 Specifications Manual
© Tait Electronics Limited May 2005
Tone on Idle
Frequency
Level*
Activation
* Adjusting nominal line level shall not alter the relative
level of the tone
1.3 kHz to 2.5 kHz adjustable via internal
potentiometer
–14 dB to +3 dB relative to the nominal line output
level
Internal jumper settings
Receiver Audio Section - Gating Operation (Continued)
Receiver Audio Section - General
Outputs Available speaker output via user interface
balanced and unbalanced line outputs via system
interface board (see “System Interface” on page 13)
Frequency Response flat or de-emphasised (750 µs) on balanced output
flat on unbalanced output
De-emphasised Response
Bandwidth
Response
300 Hz to 3 kHz (NB)
300 Hz to 2.8 kHz (MB)
300 Hz to 2.55 kHz (WB)
within ±3 dB of a – 6 dB / octave de-emphasis curve
(ref. 1 kHz)
Flat Response
Bandwidth
Response
Bulk Delay
Receiver*
Audio Tap Out R2
Audio Tap Out R4
Talk Through Repeater**
*from antenna to audio output
**from antenna input to antenna output
≤ 2.5 ms
≤ 7.5 ms
≤ 20 ms
Balanced Audio Unbalanced Audio
300 Hz to 3kHz (NB)
300 Hz to 2.8 kHz (MB)
300 Hz to 2.55 kHz (WB)
within ±3 dB of a – 6 dB /
octave de-emphasis curve
(ref. 1 kHz)
300 Hz to 3 kHz (NB)
300 Hz to 2.8 kHz (MB)*
300 Hz to 2.55 kHz (WB)
within ±3 dB of output
level at 1 kHz