User's Manual
Table Of Contents
- Specifications Manual
- Tait Contact Information
- Contents
- Preface
- 1 System Specifications
- Supply
- Power Consumption @ 13.8 VDC
- Power Consumption Band B1, 25 W*
- Power Consumption Band B1, 50 W*
- Power Consumption Band H5, 25 W*
- Power Consumption Band H5, 40 W*
- Power Consumption Band H6, 25 W*
- Power Consumption Band H7, 40 W*
- Transmitting into 5:1 VSWR*
- Channel Data
- Environmental
- Physical
- Isolation
- RF Compliance
- EMC Compliance
- Environmental Compliance
- Safety Compliance
- General
- 2 Receiver Specifications
- 3 Transmitter Specifications
TB7100 Specifications Manual Transmitter Specifications 27
© Tait Electronics Limited May 2005
Adjacent Channel Power
Steady State (Full Deviation)
Narrow Bandwidth
Mid and Wide Bandwidth
Transient (Unmodulated)
Narrow Bandwidth
Mid and Wide Bandwidth
< – 60 dBc (ETS 300 086, EIA)
< – 70 dBc (ETS 300 086, EIA)
< – 50 dBc (ETS 300 113)
< – 60 dBc (ETS 300 113)
Wideband Noise*
± 1 MHz
*no modulation, measured from centre frequency,
measured in 15 kHz bandwidth
< – 100 dBc
Intermodulation – 40 dBc with interfering signal at – 30 dBc at TB7100
base station RF output
Radiated Spurious Emissions
Transmit - B, C and H Bands
Standby
< – 36 dBm EIRP to 1 GHz
< – 30 dBm 1 GHz to 4 GHz
< – 57 dBm EIRP to 1 GHz
< – 47 dBm 1 GHz to 4 GHz
< – 47 dBm 1 GHz to 12.75 GHz
Conducted Spurious Emissions
Transmit - B, C and H Bands
Standby
Voltage and Temperature Extremes*
*(AS4295)
< – 36 dBm to 1 GHz
< – 30 dBm 1 GHz to 12.75 GHz
< – 50 dBm discrete emissions <700 Hz bandwidth
< – 57 dBm to 1 GHz
< – 47 dBm 1 GHz to 12.75 GHz
< – 30 dBm 9 kHz to 2.9 GHz
TXKEY Input Transmit Key Time
Key Up
25 W to 90% full power
25 W to mod path*
Key Down
25 W release to –10 dBm
*T8 enabled
≤ 8 ms
≤ 18 ms
≤ 6 ms
Transmitter RF Section (Continued)