User's Manual

22 Connections TB7100 Installation Guide
© Tait Electronics Limited March 2006
Serial Data
Connector (IOIOI)
The serial data connector (J1054) labelled IOIOI is a 9-way female D-range
connector, which provides a data connection to the base station.
Programming/Micro
phone Connector
(PROG/MIC)
The PC running the programming and calibration application is connected
to the base station via the programming/microphone connector (SK3) of
the UI board. The programming/microphone connector is an 8-way RJ45
socket.
Use the TPA-SV-006 or the T2000-A19 programming lead and a
TMAA20-04 adapter to connect the PC to the base station. It is possible to
plug the RJ11 directly into the RJ45 socket without the use of the adapter,
but this is not recommended. A microphone can also be connected to the
base station via this connector.
Pin Signal Name Signal Type Notes
1 not connected not used
2 receive data output data transmitted by TB7100
3 transmit data input data received by TB7100
4 not connected not used
5 ground ground
6 not connected not used
7 ready to transmit output request to send
8 clear to send input clear to send
9 not connected not used
h
j
b
g
i
c
d
e
f
external view
Pin Signal Name Signal Type Notes
1 not connected not connected
2 +13V8_SW output +13.8V, 250mA
3 TXD input transmit data
4 PTT input PTT
5 MIC_AUD_IN input voice band (microphone) input
6 GND ground
7 RXD output receive data
8 not connected not connected
12345678
external view