User's Manual

Table Of Contents

TBA0STU/TBA0STP CTU Operation Manual Introduction 7

1Introduction

The base station calibration and test unit (CTU) is designed to make it easier

to connect a Tait base station to standard test equipment, and to a PC

running the appropriate programming and calibration software. The CTU

can be used with TB7100, TB8100 and TB9100 base stations, and comes

with a selection of connection cables, tuning tools and other accessories

(refer to “Appendix A - CTU Accessories” on page 35).

Note Some features of the CTU are used with only one base station,

while others serve different functions with different base stations.

Any differences in function are explained in each chapter.

This manual describes both the TBA0STU and TBA0STP CTUs. The

only difference between the units is that the TBA0STP was not supplied

with the TB7100 CTU adaptor board. For information on the earlier

TBA0ST1 CTU which was introduced with the TB8100 base station, refer

to TN-778.