User's Manual

Pleasefollowbelowstepstoinstallthebattery.
Step1.
Insertthebattery(CR2032)withthepositive(+)sideup.
☆Makesurethebatteryishookedbythecontactspring.
Step2.
PutontheO‐Ringinthegrooveto
ensurewaterresistance.
☆MakesuretoplacetheO‐Ring
properlyinordertopreventbattery
compositionfrombeingspoiledby
sweatandmoisture.
Step3.
PlaceBatteryCover.
Step4.
TightenBatteryCover.
Forbestperformance,wettheelectrodeswithwaterorECGgelbeforeinstallingthebelt.Thismakesit
easierforbothelectrodestopickuptheheartbeatECGsignal.
1.Attachtheheartratesensortothetwospringclaspsonthewebbing,withthefontLifevisafacingup.
Blue pulse
®
HEART RATE TRANSMITTER– User Manual
ThankyouforpurchasingLifeVisaproducts.Thismanualcontainsinformationrequiredto
usetheHeartRateTransmitter.Pleasereadthismanualindetailbeforeuse.
TRANSMITTER BATTERY INSTALLMENT
ThisTransmitterincludesa3VCR2032lithiumbattery.
Applicability to Smart Phone, Heart Rate Monitor and Sports Equipment
2. ConnectonesideofFabricStraptotheelasticstrap.Thenwearitover
yourchestandmeetthestrapwiththeTransmitterattheotherside.
3.Adjustthestraplengthtofitaroundyourchestsnuglyandcomfortably,justbelowthepectoral
muscles.
4.Checkthatthewetelectrodeareasarefirmlyagainstyourskinandthat
thelogooftheTransmitterisinacentral,uprightpositionLifevisaletterLtowardtotheright
handside.
Nowyoucanstarttraining.
NOTE:

☆ Dryelectrodeareascontactwithskinwillcauseheartratesignals
detectionunstableorerroneous"0"reading,especiallyatthe
beginningofexercisingorcolddrywintermonths.
HOW TO WEAR THE TRANSMITTER
Theheartratebandconsistsoftwoconductiveelectrodes,whichareusedasthemain
componentstosensetheheartbeat.
After putting on the chest strap, the mobile phone or the settings to be connected,
such as: a treadmill with a Bluetooth heartbeat receiver, must complete the connection
with the chest strap within one minute, otherwise the electronic device on the chest
strap will automatically enter sleep status.
In this case, the user only needs to unplug the heart rate sensor from the chest strap,
and then re-attach the heart rate sensor to the chest strap to restart the connection
function.
System Pairing
Select the appropriate APP and pair it
with the heart rate sensor
Troubleshooting & Maintenance
Theheartratetransmittercheststrapisahightechproduct,sothatcarefulmaintenanceis
necessary.
●Afteruse,pleasewashtheelectrodeareaoftheheartratetransmitterwithwater
andusecleanclothtowipeit.
●Theheartratetransmitterhastobestoredunderdrycondition,andkeptaway
fromanenvironmentatextremetemperature.
●Pleaseplacetheheartratetransmitterhorizontallyifnotuse.Pullingorbending
isinhibitedtopreventtheelectrodeareafromdamage.
●Donotplacetheheartratetransmitteronametalsurfaceorinproximity
tomagneticarea(includingmagnet).
●TheelectrodeareaandECGpasteshallnotbeusedoninjuredskin.
●Theskinshallbekeptcleanbeforeandafterusingtheheartratetransmission
cheststrap.
1
ELECTRODES
2
3
LifevisaBluetoothconverterapplication
4
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment. (Example - use
only shielded interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits s
et forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 0.5 centimeters between
the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 0.5 cm
from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.