User's Manual

Digital Wireless Microphone User Manual

6. Pairing Instructions (Only conducted by installers and service technicians)

6.1 Please plug in the power adapter to turn on the DWR-882 Receiver, and connect to

an amplifier with the φ6.3 signal cable.

6.2 Please install batteries on the DWM-880/DWM-881.

6.3 Press reset button on Receiver, the LED will blinking, and you will hear continuous

beeps simultaneously.

6.4 Press reset button on Handheld Microphone/ Wireless Transmitter, the LED will

blinking.

6.5 When the LED on Handheld Microphone/ Wireless Transmitter blinks

simultaneously with LED(A CH or B CH) on Receiver, the program performs

pairing automatically and it takes about 15 seconds. When the pairing is

completed, you will hear a long beep, then LEDs will constantly on, now you have

completed the pairing process successfully.

6.6 If the paring failed, please repeat steps 6.3~6.4 , and speed up the process.

7. Troubleshooting

7.1 No sound

7.1.1 Check if the power to Digital Wireless Receiver is well connected.

7.1.2 If the status LED is not lit when the Digital Wireless Transmitter/Microphone

been switched on, check whether the batteries are properly installed according

to the polarity marks or have enough energy.

7.1.3 The transmission range is 20 meters between Digital Wireless Transmitter and

Digital Wireless Receiver, so the output audio might be inconsistent if the

transmission range is exceeded.

7.2 Interferences

In order to solve the disturbances from other devices that are using neighbor

frequencies or from other 2.4G wireless appliances nearby, fitting a slotted

screwdriver into the slot, and rotate the switch clockwise or counter-clockwise.

8. Specification

8.1 Digital Wireless Receiver

Model : DWR-882

Power Consumption : 7.5W

Receiving Sensitivity : -85dBm

Volume Adjusting Range : 0~20dB

Output Jack : ø6.3mm Mono Female Jack

Rated Output Power : 7.5W (4

Ω loaded, THD=10%)

Dimension : 284(L) × 157(W) × 211(H) mm