User's Manual

Digital Wireless Microphone User Manual
9
Figure 4.4
5. Bodypack Wireless Transmitter Operating Instruction
5.1 Connect a head-worn or lapel condenser microphone to the ø3.5mm Earphone Jack
on the Transmitter.
5.2 Push the Power Switch on the Transmitter to ON as shown in figure 5.1, and the
Power LED will light up red, it indicates the Transmitter is on. When the
microphone connection status LED on the Receiver lights up red, it indicates the
Receiver has already picked up the signals from Microphone, so you can now talk
to the microphone.
Figure 5.1
5.3 If a feedback noise appears when the volume is too high or the microphone is too
close to the speaker, turn the volume down.
5.4 When mute is needed, push the Power Switch on the Transmitter to ST.BY position
as shown in figure 5.2. To unmute the audio signal, simply push the Power Switch
back to ON position.
Power Switch, push to ON
Power Switch, push to ST.BY
Fit the slotted
screwdriver into
this slot.
When selecting
the channel, aim
the arrow at the
scale or in
between two
scales.