User's Manual

P30.
SETUP MODE
HOW TO DELETE AN INDIVIDUAL EXISTING USER CODE
Steps as following:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice. You
are now under setup mode.
2. Enter 123456 (or a current programming code) and then press button . Enter [30] and press
button . Enter existing user code (that you wish to delete) and press button .
3. The Red LED will light up for 10 seconds. The lockset will delete the existing user code that you
do not want.
(If a number of user codes are to be deleted at the same time, enter each user code to be deleted and press
prior to the indicator light timing out 10 seconds after the last press of a keypad button.)
Note:
1. The lockset will go back to the standby status if no button is pressed in 10 seconds after
accessing setup mode.