User's Manual

P33.
SETUP MODE
HOW TO DELETE ALL EXISTING USER CODES AT ONCE
Steps as following:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice. You
are now under setup mode.
2. Enter 123456 (or current programming code) and then press button . Enter [40] and press
button .
3. The Red LED will light up for 10 seconds. The lockset will delete all existing user codes.
Note:
1. The lockset will go back to the standby status if no button is pressed in 10 seconds after
accessing setup mode.