User's Manual

P38.
SETUP MODE
HOW TO ENABLE AUTO-LOCK MODE
Steps as following:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice. You
are now under setup mode.
2. Enter 123456 (or current programming code) and then press button . Enter [80] and press
button .
3. Enter [0] and press button . The Red LED will light up for 10 seconds. The lockset will turn
on auto-lock mode.
4. Enter [1] and press button . The Red LED will light up for 10 seconds. The lockset will turn
off auto-lock mode. (Default auto-lock mode is off)
Note:
1. The lockset will go back to the standby status if no button is pressed in 10 seconds after
accessing setup mode.
2. The lockset will auto-lock in 10 seconds (default value) without flashing and beeping
after unlocking if you turn on auto-lock mode.
3. The lockset can still be locked by pressing button manually even if you turn on
auto-lock mode.