Taiyuan Edge® R/C Consumer Service We want to assist you! DO NOT RETURN THE PRODUCT TO THE STORE! * Log on: Click “Service” at www.taiyoedge.com E-mail: TOLL-FREE CONSUMER HELPLINE 1-866-4-EDGE-RC (1-866-433-4372) A BAT a CANER'S MANUAL SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. THEY CONTAIN IMPORTANT INFORMATION. Important! Please read your Owner's Manual all the way through before operating your vehicle. Safety First + Adult supervision is recommended.
Handling EdgeRunner® Always pick up and hold your Edge Runner vehicle from the back as shown, or from the front and back with both hands. Keep hair, hands, fingers, face and loose clothing away from wheels while the vehicle is switched on or while the transmitter is operating. Never pick up by the wheels. {Fig. 1) Battery Charging and Care Vehicle will not run without a 6.0V rechargeable Ni Cd or Nigh battery pack and matching charger, commonly available for R/C vehicles at many toy and hobby dealers.
. Slide BATTERY PACK all the way in direction of ARROW {toward back of vehicle} until it stops. (Fig. 4) 4. Turn LATCH ali the way to CLOSED position to secure BATTERY PACK inside BATTERY OPENING. (Fig. 5) Transmitter Battery Installation 1. Slide open BATTERY DOOR on back of TRANSMITTER. (Fig. 8} 2. Insert a fresh, new 9-VOLT ALKALINE BATTERY with the polarity as shown on the bottom of battery compartment. {Fig. 7} 3. Hold battery in place with thumb and replace BATTERY DOOR. (Fig. 8) 4.
Gunrunner Tips 1. In order to race or operate two vehicles together, one must be MHz and one must be MHz. R/C Facts for Improved Operation 1. When battery start to fully discharge, vehicle may slow, stop, or refuse to respond to your control. It's time to recharge vehicle battery or replace transmitter battery. This is absolutely the #1 cause of all problems and questions! 2. Radio frequency interference can interfere with the control of your vehicle.
Taiyuan Edge*® R/C Consumer Service We want to assist you DC NOT RETURN THE PRODUCT TO THE STORE! © Log on: Click “Service” at www.talyoedge.com E-mail: TOLL-FREE CONSUMER HELPLINE EDGE RUNNER 2 STUNT GUIDE Important! Please read your Owner's Manual (also inside box) all the way through before operating your vehicle. SAVE THIS GUIDE FOR FUTURE REFERENCE. IT CONTAINS IMPORTANT INFORMATION. important Safety and Operating Information » Adult supervision is recommended.
Edge Runner Stunt Tips, Continued 3. Some stunts require a ramp, which you need to supply. You can build your own {Adult Supervision Required). Suggested materials for a simple ramp include a plywood board {a suggested size might propped angle with a 1" or thicker piece of wood or other material {4” wide by about 18" tall in our example) as shown, 4. Some of the stunts will work best on particular surfaces.
Grind the Pegs ¢ 13 16 Step 1 Step 2 Surface: Low grip, . smooth concrete, tile, wood or sealed asphalt 1. Hold until vehicle is doing rapid 360s. 2. Push right stick forward sharply, hold Surface: High-grip asphalt or rough concrete 1. Run forward about 20 feet to build up speed 2. Pull both sticks backward sharply and hold Degree of Difficulty: 3 Wheelie Step 1 Step 2 Surface: High-grip asphalt or rough concrete 1. Drive backwards a few feet 2. Push both sticks sharply forward Variations: Roof side down.
Freestyle Step 1 Surface: High-grip asphalt or concrete. Clean and free of debris. Start with roof down, large wheels forward. 1. Both sticks up. Drive forward 20-30 feet to build speed. 2. Reverse and both sticks sharply at the same time, and hold as vehicle bounces on one or more wheels while flipping. Degree of Difficulty: 6 Sick Peg Flip Surface: Low gfe. smooth concrete, tile, wood or sealed asphalt 1. Hold until vehicle is doing rapid 360s. 2.
Get Big Air SET DOWN HERE APPLY POWER HERE REVERSE STICKS WHEN AIRBORNE Degree of Difficulty: 9 i Surface: Skateboard park half pipe 1. Place vehicle wheels on down slope of half pipe and release. 2. Apply power at bottom, hold power on until vehicle clears opposite pipe Sick 720 Degree of Difficulty: 10 | Surface: Skateboard park half pipe : Place vehicle wheels on down slope of half pipe and release. 1. Apply power at bottom, hold power on until vehicle clears opposite pipe. 2.
PLYWOOD RAMP Surface: Jump ramp at about 20° angle. (See Tip 3) 1. Stand behind vehicle and drive straight forward at full speed for 20-30 feet before Degree of Difficulty: 7 ramp. Gyro Jump Degree of Difficulty: Surface: Jump ramp at about 20° angle. Run vehicle forward for 20-30 feet before ramp, 1. Get air 2. As soon as vehicle clears edge of ramp, pull both sticks sharply back for gyro-tongue reaction. Run the Edge Degree of Difficulty: 8 Step 1 Step 2 Surface: Low grip concrete or asphalt.
