User Manual

- 52 -
CL5ADAH2Z
Confidential
2020.11.05 rev.1.1
Antennas
This radio transmitter CL5ADAH2Z has been approved by the FCC and ISED to operate with the
maximum permissible gain indicated below.
Modulation
Freque
ncy (M
Hz)
Maximum p
ermissible gain
approved by the FCC (dBi)
Maximum permissible gain
approved by the ISED (dBi)
LTE Band 2 1850 ~ 1910
8.00 8.00
LTE Band 4 1710 ~ 1755
5.00 5.00
LTE Band 12 699 ~ 716 8.70 5.63
LTE Band 26 824 ~ 849 9.41 6.12
LTE Band 26 (Part 90S) 814 ~ 824 9.36 N/A
T
est Modes
Taiyo Yuden Co., Ltd. uses various test mode programs for test set up which operate separate from
production firmware. Host integrators should contact Taiyo Yuden Co., Ltd. for assistance with test
modes needed for module/host compliance test requirements.
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warming as shown in
User manual.
In the end product, the antenna(s) used with this transmitter must not be co-located or operation in
conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures. User and installers must be provided with antenna installation instructions and
transmitter operating conditions for satisfying the RF exposure compliance.
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference
and
2) this device must acce
pt any interference received, including interference that may cause undesired
operation of the device.