User's Manual

8-Apr.2019 Ver.0.5

TAIYO YUDEN CO., LTD.

2/3

EYSKJN

Since this module is not sold to general end users directly, there is no user manual of module.

For the details about this module, please refer to the specification sheet of module.

This module should be installed in the host device according to the interface specification

(installation procedure).

The following information must be indicated on the host device of this module;

1) Japan Regulatory Information

a) This Product is a radio system and obtained certification of construction type combined

with the specific antenna.

b) Please ensure that your product has a label with the following certification mark at easily

viewable location. If your product is too small to have the label, please place it in the

instruction manual and package of your product. In case your product does not have the

label with the following certification mark, you or your customer who uses your product

may be against the Radio Law and subjected to criminal punishment. TAIYO YUDEN

shall not be liable for any loss or damage incurred by you or your customer arising from

use of your product which does not have following certification mark.

This product has a radio system which was approved as a radio station in a low

power data communication system based on the Radio Law.

EYSKJN : 001-A＊＊＊＊＊

2) Canada Regulatory Information

a) This device complies with Industry Canada’s applicable licence-exempt RSSs.

Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux

appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions

suivantes :

1) l’appareil ne doit pas produire de brouillage;

2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d’en compromettre le fonctionnement.

b) This product is certified as type of the portable device with Industry Canada Rules. To

maintain compliance with RF Exposure requirement, please use within specification of

this product and have a separation distance of minimum 15 mm between the user

and/or bystander and the antenna and /or radiating element.

This distance ensures that the output power (e.i.r.p.) of EYSKJN is below the SAR

evaluation Exemption limits defined in RSS-102 issue 5.