User's Manual

Vehicle Battery Installation

1. Slide vehicle BATTERY DOOR open and remove as shown. (Fig. 1)

2. Insert 2 fresh, new Alkaline batteries into battery compartment as

shown. IMPORTANT: OBSERVE BATTERY POLARITY (DIRECTION, +

AND -). (Fig. 2)

3. Replace BATTERY DOOR and slide closed until it latches. (Fig. 3)

Remote Battery Installation

1. Slide open BATTERY DOOR on REMOTE and remove. (Fig. 4)

2. Insert a fresh, new 9-VOLT ALKALINE BATTERY with the polarity

(+/-) as shown on the bottom of battery compartment. (Fig. 5)

3. Replace BATTERY DOOR and slide it closed to secure. (Fig. 6)

Vehicle Operation

1. Turn on POWER SWITCH on bottom of vehicle. (Fig. 7)

2. Vehicle operates best on flat, smooth, surfaces. KEEP AWAY

FROM WATER, SNOW AND WET SURFACES.

3. If vehicle steers slightly to one side or the other when you

press a button to go straight, move the TRIM TAB on the

bottom in the opposite direction, a little at a time. (Drive vehicle

away from you to test.) Repeat if necessary. (Fig. 8).

Fig 7

Fig 8

POWER

SWITCH

TRIM

TAB

R/C Tip

In order to race or operate two vehicles together, they must

be different frequencies. Check the package and the bottom

of your vehicle for the frequency label.

Remote Operation

Press and hold a "dialing" button to move the vehicle in the direction

shown by the arrow on the button. Release button for "neutral."

Note: There is no on/off switch on Remote. Pressing the buttons turns it

on. Releasing the buttons turns it off.

Forward

Right Forward

Left Forward

Reverse

Right Reverse

Left Reverse

Left Right

Fig 1 Fig 2 Fig 3

Fig 4 Fig 5 Fig 6

ANTENNA

Extend antenna fully for operation. Hold Remote so antenna points straight up

in the air. Don't touch during operation.