Manual
- 30 -
(unit:°F)
Temperatures available under the High Temperature Mode
NORMAL OPERATION
Flow rate to activate the 910 (T-M50) : 0.5 gallon per minute
Flow rate to keep the 910 (T-M50) running : 0.4 gallon per minute
1. NORMAL OPERATION
WITHOUT REMOTE CONTROLLER
1.
Open a hot water tap.*
2. Mix cold water with the hot to get
the correct temperature water.
3. Close the hot water tap.
*If a remote controller installed, turn the remote controller ON by pressing the power ON/OFF button on the remote
controller and then set the temperature by pressing the HOT/COLD buttons before opening a hot water tap. The
temperature is displayed when the remote controller is turned ON.
2. NORMAL OPERATION
WITH REMOTE CONTROLLER INSTALLED: 9007603005 (TM-RE30) (Optional)
1. Press the power ON/OFF button. 2. Set temperature. (Example 110°Ｆ)
WARNING
Hot Water temperatures over 125F (52ºC) can cause severe burns instantly or death from
scalding.
The outlet hot water temperature of the water heater is factory set at 120F (49ºC).
Feel the water temperature before bathing or showering.
100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175
110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185
The temperature and the
time will be displayed on
the remote controller.
Temperatures available under the Default Mode
3. Open a hot water tap.
Mix cold water with the hot if you need.
4. Close the hot water tap.
DO NOT set to 185°F if you use your water heater in recirculation system. Refer to p.33
When ON,
green LED is lit.
Lamp is OFF
Lam
p
is OFF
Lamp is ON
Lam
p
is ON