User's Manual

Manual No.TDR-MNL-L4D01-24-EN-090
TAKAYA RFID TR3 Series
Regulations and Standards
FCC
This product is conform to the FCC standards.
FCC Rules (Federal Communications Commission)
This product complies with Part 15 Subpart B and C of the FCC Rules.
FCC ID : MK4TR3-L4D01-24
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment must be professionally installed to ensure compliance with Part 15.
Antennas not allowed are strictly prohibited for use with This equipment.
This equipment is to be professionally installed by professional service trained personnel only.
SMB sockets are provided in the equipment for connecting the external antenna.
The following sentence has to be displayed on the outside of the device in which the transmitter module
is installed : “Contains FCC ID: MK4TR3-L4D01-24”
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The antenna(s) used for this transmitter must not be collocated or operating in conjunction with any
other antenna or transmitter within a host device,
except in accordance with FCC multi-transmitter product procedures.
The final system integrator must ensure there is no instruction provided in the user manual or customer
documentation indicating how to install or remove the transmitter module except such device has
implemented two-ways authentication between module and the host system.
FCC §15.27 b) - Special Accessories –
If a device requiring special accessories is installed by or under the supervision of the party marketing
the device, it is the responsibility of that party to install the equipm ent using the special accessories.
For equipment requiring professional installation, it is not necessary for the responsible party to market
the special accessories with the equipment.
However, the need to use the special accessories m ust be detailed in the instruction manual, and it is
the responsibility of the installer to provide and to install the required accessories.