Talk Electronics User Manual TALK ELECTRONICS LTD. UNIT 3 IMAGE HOUSE 326 MOLESEY ROAD HERSHAM SURREY KT12 3PD ENGLAND T EL: +44 (0)1276 709966 FAX : +44 (0)1276 682843 E-MAIL: info@talkelectronics.com www.talkelectronics.
Talk Electronics Cyclone User Manual INTRODUCTION Thank you for choosing a Talk Electronics Cyclone Integrated amplifier. We are confident that it will provide you with many years of musical enjoyment and reliable service. However, please take the time to read this guide thoroughly before using the amplifier. It explains how to install and connect it, and suggests how to ensure that you always enjoy its optimum performance.
SIGNAL CONNECTIONS The Cyclone integrated amplifiers were developed using high quality interconnects and speaker cables from Merlin Cables, these allow the amplifiers to operate as intended and deliver their optimum performance. We strongly recommend that you use these cables for all connections.
one and record on the other. Whilst Tape 1’s output is permantly connected to Tape 2’s record out sockets you will need to select Tape 2 in the record mode to send the output of tape 2 to the record sockets of Tape 1. REMOTE CONTROL OPERATION. The Cyclone’s remote control window is situated at the bottom of the front panel just to the left of the volume control. The remote control handset must have an unobstructed view of this window in order to pass instructions to the amplifier.
SPECIFICATION CYCLONE 1.1 CYCLONE 2.1 Power output 20-20K 8 Ohms Distortion 1KHz 10W 8Ohms S/N Ratio Residual noise Frequency response 5-100KHz Dimensions H.W.D in mm excluding connections Weight packed un-packed 70W <=0.01% <= -80dB A weighted <= -62dB unweighted +/- 3dB 93x430x300 8.90kg 7.50kg 100W <=0.008% <= -80dB A weighted <= -62dB unweighted +/- 3dB 93x430x300 8.90kg 7.
