User's Manual

192.0 Configuring TalkSwitch
Choose a Remote Extension to configure. After you have activated a Remote
Extension, you must enter a phone number in order for the extension to be
considered active and usable by the system.
Remote phone number:
Enter the phone number of the Remote Extension (note: no specific prefixes are
required - put the number in just as though you were dialing it from a regular
phone). You may use the following in the space provided: digits 0 – 9, space,
comma, dash, # and * .
Last Name/First Name:
Enter the first and last name of the person associated to the extension. The last
name is required if the person is to be included in the ‘Dial by Name’ directory
listing used at the Auto Attendant level. The person using that extension must
also record their name for the directory. Instructions for recording the name are
listed in the interface.
Connect using:
Select the Line Hunt Group that TalkSwitch will use to connect to that Remote
Extension. For example if you have an inexpensive long distance carrier setup for
the lines in Hunt Group 84, you may want to use this Hunt Group for your long
distance Remote Extensions.