UNI-PGRM Data Sheet

Tamarack Solar
Products
[e-mail] 800-819-7236
1435 Baechtel Road, Willits CA
• e PGRM Series Pole Mount can be used to mount up to 6 solar
modules with a frame thickness between 1.18” and 2”
• Install up to 92 square feet of modules on a single 4” Schedule 40 pole
and up to 130 square feet of modules on two 4” schedule 40 poles
• Suitable for wind speeds up to 115 MPH. For high wind speed areas
use 2 vertical poles on mounts with 4 or more modules
• Tilt angle can be adjusted from 0° to 90° and is easily adjusted sea-
sonally
• All sizes can ship by UPS Ground
• Simple one-person installation and adjustment
PGRM POLE TOP MOUNT
User supplies 4” schedule 40 steel pipe(s) for vertical pole and a 3” schedule 40
steel pipe for the horizontal beam. Calculation of the required horizontal beam
length (L) in inches:
L = 5 + (Q x W) + ((Q-1) x 1.28 where Q = module quantity, W = module width
Part Number Description
UNI-PGRM/1P1 POLE MOUNT FOR 1 MODULE WITH 1 VERTICAL POLE
UNI-PGRM/2P1 POLE MOUNT FOR 2 MODULES WITH 1 VERTICAL POLE
UNI-PGRM/3P1 POLE MOUNT FOR 3 MODULES WITH 1 VERTICAL POLE
UNI-PGRM/4P1 POLE MOUNT FOR 4 MODULES WITH 1 VERTICAL POLE
UNI-PGRM/5P1 POLE MOUNT FOR 5 MODULES WITH 1 VERTICAL POLE
UNI-PGRM/5P2 POLE MOUNT FOR 5 MODULES WITH 2 VERTICAL POLES
UNI-PGRM/6P1 POLE MOUNT FOR 6 MODULES WITH 1 VERTICAL POLE
UNI-PGRM/6P2 POLE MOUNT FOR 6 MODULES WITH 2 VERTICAL POLES
70-0300-PGM ADDITIONAL POLE CAP FOR HIGH WIND LOCATIONS
PGRM-MID SPARE MID CLAMPS - USED BETWEEN EACH MODULES
PGRM-END SPARE END CLAMPS - FOR END OF ROW
29-08RC-000 END CLAMP FOR MODULES WITH CROSS BARS IN FRAME - USE 1 PER MOUNT
If you are installing solar modules with rear cross supports, order 29-08RC-000
VERTICAL AND HORIZONTAL SCHEDULE 40 PIPE IS NOT INCLUDED - PURCHASE LOCALLY