Flush Mount Installation Guide

2019 TAMARACK SOLAR - REVISION G FLUSH MOUNT MANUAL
10
Module Level Power Electronics
Use the Tamarack MLPE Rail
Adapter to attach Enphase microin-
verters or SolarEdge Optimizers to
the rails.
The large at washer is installed
between the mounting plate of
the MLPE and the top of the rail.
Tighten the bolt with a 1/2” socket
to the proper torque.
Wire Management
Place electrical conductors and connectors at the bottom of the rail
channels.
Install the wire protection clips where necessary to keep wires in the
channels.
When using 1.6 inch rail, it is possible to damage connectors or large
bundles of wire when 50-50 bolts are tightened. Position connectors
and bundles appropriately to prevent risk of ground faults.