Flush Mount Installation Guide
2019 TAMARACK SOLAR - REVISION G FLUSH MOUNT MANUAL
11
Module Installation
Start module installation at one end of the rails. If there
are multiple rows, start on the bottom row.
Install a 50-50 clamp at the end of each rail with the side
of the clamp with 2 bonding pins on the module frame.
Push the channel nut into the rail. The integrated spring
assembly will hold the clamp in place.
Place the rst module onto the rails so that it is centered
over the rails. Make sure the module is touching the
inside edge of the clamps and tighten the clamps with a
1/2” socket.
Install 50-50 Clamps in each rail on the other side of the
rst module. The springs will hold the clamps in place
prior to tightening. Place the second module on the rails,
align it with the rst module, and push in against the
clamps. Tighten the clamps to fully secure the module.
Install the remaining modules and clamps on the rails in
the same manner, aligning the corners of the modules.
On the outside edge of the last module, install the
clamps so that the side with the two stainless-steel pins
is on the module frame. Tighten all bolts to the specied
torque.