Flush Mount Installation Guide

2019 TAMARACK SOLAR - REVISION G FLUSH MOUNT MANUAL

Do a nal check to be sure that all installation hardware on

the array is properly tightened.

Channel End Clamps

Channel End Clamps may be used in place of the 50-50

clamps at the ends of rails. Channel Clamps secure the

module frame from below and allow the rails to be cut ush

to the edge of the array for a clean look.

Insert channel end clamp in the rail. The module must be lifted slightly to slide the clamp un-

der the frame.

Allow the module to rest on the rail again and slide the clamp back toward the end of the mod-

ule until it is ush with the outside end of the module frame and tighten lightly. Feel under the

array to check that the clamp is clamping the module ange securely, then tighten to the speci-

ed torque.

End Caps

Place an end cap at the end of each rail to inprove the look of the system. Drain holes on the

bottom of the end caps ensure that water does not accumulate in the rails.