Flush Mount Installation Guide
2019 TAMARACK SOLAR - REVISION G FLUSH MOUNT MANUAL
14
Disclaimer
This manual describes proper installation procedures and provides necessary standards required for product reli-
ability. Warranty details are available on our website. www.tamaracksolar.com
All installers must thoroughly read this manual and have a clear understanding of the installation procedures
prior to installation. Failure to follow these guidelines may result in property damage, bodily injury or even
death.
Installers Responsibilities
• Follow all applicable local or national building and re codes, including any that may super
sede this manual.
• Electrical installation should be conducted by a licensed and bonded electrician or solar con
tractor.
• Module maintenance or removal must not break the bonding path of the system.
• Ensure all products used are appropriate for the installation and array under the site’s loading
conditions.
• Use only Tamarack parts or parts approved by Tamarack; substituting parts may void any ap
plicable warranty.
• Comply with all applicable re codes including, but not limited to, keeping walkways clear.
• Ensure bare copper grounding wire does not contact aluminum and zinc-plated steel compo
nents, to prevent risk of galvanic corrosion.
• If loose components or loose fasteners are found during periodic inspection, retighten imme
diately. If corrosion is found, replace aected components immediately.
• Provide an appropriate method of direct-to-earth grounding according to the latest edition of
the National Electrical Code, including NEC 250: Grounding and Bonding, NEC 690: Solar
Photovoltaic Systems, and CSA C22.1, Safety Standard for Electrical Installations, Canadian
Electrical Code, Part 1
• Disconnect AC power before servicing or removing microinverters and power optimizers.
• Review module manufacturer’s documentation to ensure compatibility and compliance with
warranty terms and conditions.
• Maximum Series Fuse Rating of 20 Amps.