Instructions / Assembly
Page 6
Connect to fan to power using factory-
installed power cord (10 ft).
Suspend fan from rafters using hanging strap.
Secure hanging strap to rafters using wood screws
(1½"minimumlength,NOTprovided)throughthe
pilot holes on strap; washers recommended between
screw heads and straps. USE BOTH SIDES OF
STRAP AND KEEP FAN AS LEVEL AS POSSIBLE.
Fan installation
All wiring connections to and from fan are
made at fan-mounted electrical box.
Face of fan must remain unobstructed; 24-
INCH MINIMUM CLEARANCE REQUIRED.
Route all wiring away from face of fan to
prevent entanglement.
Center Powered AirLock over rough
opening and mount it to framing using
the 4 provided mounting screws through
the pilot holes. From below, use a high-
quality latex caulk to seal all wood-to-
wood and wood-to-metal seams within
the rough opening.
Use bolts to fasten fan cone to fan and latches to fasten
ductwork to fan cone.
Once the fan, fan cone, ductwork, and Powered AirLock
have been successfully connected, seal these seams with
the provided aluminum tape.
Tamarack HV5800M
Whole House Fans Installation Manual, P/N HV5800M.1
©Tamarack Technologies, Inc., 2018. All Rights Reserved.