Manual
Table Of Contents
- 1. Getting started
- 2. Your B-6
- 3. Conception of the digital layout
- 4. Connections
- 5. Settings / Configuration
- 6. Operation
- 7. Update
- 8. Checklist for troubleshooting and error correction
- 9. Technical data
- 10. Warranty, EU conformity & WEEE
tams elektronik
!
!
Booster B-6 tams elektronik
Cable cross-sections
For the connection to the rails, use a cable with a cross-section sufficient for the load
(recommended cross-section: > 0.75 to 1.5 mm²).
Please note:
If the cross-section is too small, the overcurrent/short-circuit cut-off will not function reliably
and the cable may become very warm. Fire hazard!
Assignment of the poles of the track connection to the rails
The assignment of the poles of the siding to the two rails (or the rail and the centre
conductor) is initially arbitrary. However, this does not apply if you have already connected a
booster to the layout. In this case you must ensure that all booster circuits have identical
polarity!
Please note:
If the polarity of the two booster circuits is different, considerable disturbances in the data
transmission and damage to the vehicles, rails and the track outputs of the boosters can
occur when crossing the separation points!
22 | Connections