Manual
Table Of Contents
- 1. Getting started
- 2. Operation overview
- 3. Connections
- 3.1. Safety instructions
- 3.2. Safe and correct soldering
- 3.3. Avoiding irreparable damage to the decoder!
- 3.4. Pin assignment LD-G-43 | Front side
- 3.5. Pin assignment LD-G-43 | Rear side
- 3.6. Using decoders with interface connectors
- 3.7. Use of the LD-G-43 in locomotives with AC motor
- 3.8. Mounting decoders without interface
- 3.9. Connecting LEDs to the function outputs
- 3.10. Connecting inductive loads
- 3.11. Connecting the switching inputs
- 3.12. Connecting a backup capacitor or buffer circuit
- 3.13. Connection of a SUSI module
- 3.14. Completion
- 4. Programming
- 5. Configuration variables and registers
- 5.1. Overview configuration variables LD-G-43
- 5.2. Basic settings
- 5.3. Setting the address
- 5.4. Setting the motor control
- 5.5. Function mapping
- 5.6. Effects of the outputs
- 5.7. Settings for the switching inputs
- 5.8. RailCom and DCC-A settings
- 5.9. Settings for driving operation
- 5.10. Settings for analogue mode
- 5.11. Sensivity of the overload protection
- 5.12. Auxiliary functions
- 5.13. Information
- 6. Checklist for troubleshooting and error correction
- 7. Technical data
- 8. Warranty, EU conformity & WEEE
tams elektronik
LD-G-43 tams elektronik
CV-Nr. Name Anleitung Abschnitt
115 Parameter of load control KD 5.4. Setting the motor control
116 Load control 5.4. Setting the motor control
121 Configuration data 2 5.2. Basic settings
122 ABC sensitivity 5.9. Settings for driving operation
257...485 Assignment of outputs and special
functions to the functions
5.5. Function mapping
5.2. Basic settings
Name No. Input values
(Default)
Remarks and tips
Configuration
data 1
29 0 ... 255 (14) Direction "Standard" 0
Direction inverted 1
14 speed levels 0
28 or 128 speed levels (in DCC format) 2
Note: If you want to use the SDF method,
you must set the 28/128 speed level mode.
(→ section 2.1)
Note: If the decoder is run in Motorola format, the
setting of the speed step mode has no effect.
Automatic analogue recognition off 0
Automatic analogue recognition on 4
RailCom off 0
RailCom on 8
Linear velocity characteristic 0
Alternative velocity haracteristic 16
Basic addresses 0
Extended addresses (for DCC format only) 32
Tip: If the use of extended addresses is activated in
CV 29, the decoder does not react to signals in Motorola
format!
Example: CV 29 = 0 | Meaning:
Direction = "Standard". 14 speed levels . Automatic analogue recognition = "off".
RailCom ="off". Linear velocity characteristic. Basic addresses.
Example: CV 29 = 14 | Meaning:
Direction = "Standard". 28 or 128 speed levels in DCC mode. Automatic analogue recognition = "on".
RailCom ="on". Linear velocity characteristic. Basic addresses.
40 | Configuration variables and registers