Manual

tams elektronik
tams elektronik LD-G-43
5.8. RailCom and DCC-A settings
Name No. Input values
(Default)
Remarks and tips
Dynamic
RailCom
information
10 0,1 (0) off 0
Reception statistics:
The decoder keeps statistics on all
DCC packets and reports the
number of faulty packets /
total number of packets in %. 1
In order to read out RailCom information, you have to make the following additional settings:
 CV 29 "Configuration data 1": RailCom on
 CV 28 "RailCom channels": at least channel 2 on
RailCom channels
Automatic
registration
according to RCN-
218 (DCC-A)
28 0 … 135 (131) no feedback with RailCom and no
automatic registration 0
Channel 1 on 1
Channel 2 on 2
Recommendation: Always switch on channel 2
when you have switched on channel 1.
Use of Dynamic channel 1 4
The setting only has an effect if
channel 1 is switched on.
Automatic registration
according to RCN-218 (DCC-A) 128
Notes on automatic registration according to RCN-218 (DCC-A):
The use of the DCC-A procedure is only possible with digital control units that support this registration
procedure. To be able to use the automatic login via the DCC-A procedure, the following settings must be
made:
 CV 29 "Configuration data 1": RailCom on
 CV 28 "RailCom channels": channel 1 and 2 on
 CV 28 "DCC-A": on
The activation of the Dynamic Channel 1 is optional.
Notes on the use of Dynamic Channel 1:
Some RailCom detectors can only receive address messages on channel 1. If these detectors are used,
the application of Dynamic Channel 1 must not be activated.
Further information on RailCom and automatic registration according to RCN-218 (DCC-A) → section 2.9.
Configuration variables and registers | 55