Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
English LC-Modules Next Generation
To exit to programming mode, switch off the power supply. The
selected variant is saved and is active the next time the module is
switched on.
LC-NG-05 and LC-NG-14 :
Setting a programme variant
The selected programme variant is indicated during configuration by
the LED or lamp lighting up at the assigned output. Therefore, connect
LEDs or lamps to outputs 1, 2, 3 and the following before switching to
programming mode. Technically, a maximum of 8 programme variants
are possible; the number of variants actually possible can be found in
the description of the LC-NG version concerned.
Page 36