Instructions

tams elektronik
English LC-Modules Next Generation
Vehicle lighting and horn
With the LC-NG-05, the illuminations of "moving" and "parked" cars can
be simulated. At irregular intervals
 the headlights and rear lights are switched on and off
 the headlights and rear lights are switched brighter (to simulate a
headlight flasher and the brake light)
 the turn signals on the left or right side are switched on and off
 the interior lights are switched on and off
The horn is also triggered at irregular intervals. The sound of the horn
is stored on the IC.
Note on the stored sound: The LC-NG module is not intended as a sound module, the stored
sound is accordingly simple.
Use of the switching input
Switching input Effect
Switch closed
(switched to earth)
Switch to flashing yellow traffic light
Switch open
Standard procedure
Settings on the trim potentiometer
During operation, you can use the trim potentiometer to set how fast
the signal sequence for the traffic lights should be. The sequence
becomes faster in the left-hand direction* and slower in the right-hand
direction.
* Note: If the trim potentiometer is set to the left stop, the module goes into test mode when it
is switched on. You must therefore turn it a little to the right to set the fastest signal sequence
after you have set it to the left stop.
The trim pot is also used during configuration to select a variant. The
set variant is saved before exiting programming mode, so changes to
the position of the trim pot do not affect the variant setting.
Page 66