Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
English LC-Modules Next Generation
Settings on the trim potentiometer
The trim potentiometer can be used to change the speed of the chaser
lights during operation. The speed becomes faster in the
counterclockwise direction* and slower in the clockwise direction.
* Note: If the trim potentiometer is set to the left stop, the module goes into test mode when it is
switched on. You must therefore turn it a little to the right to set the highest speed after you have
set it to the left stop.
7.2. Pin assignment LC-NG-07
Connection of light bulbs
(→ page 24)
Connection of LEDs
(→ page 25)
Connection of servos
(→ page 32)
1 fast flashing (ca. 1 Hz) 14
Chaser
lights
2 fast flashing (ca. 1 Hz) 13
3 fast flashing (ca. 0,5 Hz) 12
4 Servo 1 ("crane") 11
5 Servo 2 ("road roller") 10
6 rising and falling light 9
7 flashlight 8
Required accessories
Light bulbs or LEDs with suitable series resistors
two servos, two servo boards and two resistors 470 (→ page 32)
Page 72
Order