Datasheet

Chapter 2 Installing the Tape Drive
Installing the Internal SCSI Tape Drive
DLT-V4 Product Manual 15
Unpacking the Internal
SCSI Tape Drive
2
Before you do anything else, unpack and inspect the tape drive for
shipping damage. If you notice any damage, report it both to the sales
representative and to the shipping company immediately.
If there is no damage to the tape drive, select a server or workstation to
host the tape drive, then move on to the following installation steps.
Configuring the Internal
SCSI Tape Drive
2
Configuring the tape drive is fast and easy. You only need to select a
unique SCSI ID and decide if the tape drive needs to be terminated. The
following sections explain how to configure the tape drive.
9 Connect the SCSI cable to the tape drive and
SCSI host adapter.
Connect the terminator on the tape drive—if it
is the last or only device on the SCSI bus.
page 22
10 Connect a power cable to the tape drive.
11 Secure the tape drive in the selected server or
workstation.
12 Install the server or workstation’s cover,
connect power cables to all peripheral devices,
and apply power to the server or workstation
and all peripheral devices.
13 Check the tape drive to make sure it is
working properly.
Note: Save the packing materials in case you need to move or ship
the tape drive in the future. You must ship the tape drive in
the original (or equivalent) packing materials or you will
invalidate the warranty.
Step Instruction Refer to