User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 103
14
14 Specifications
Tandberg Data StorageLibrary T40+ Series follows the specifications described in this chapter. Table
18 lists the library components available.
Table 18. Library Specification Summary
StorageLibrary
T40 T40+ T80+ T120+
Maximum Storage
Slots Available
40 slots 40 slots 77 slots 114 slots
Maximum Capacity
LTO3
(native/compressed)
16 / 32 TB 16 / 32 TB 30.8 / 61.6 TB 45.6 / 91.2 TB
Maximum Capacity
LTO4
(native/compressed)
32 / 64 TB 32 / 64 TB 61.6 / 123.2 TB 91.2 / 182.4 TB
Maximum Drive
Capacity
4 4 8 12
Maximum Number of
Power Supplies
1 2 4 6
Number of Physical
Libraries
1 1 2 3
Number of Logical
Libraries
1 1 1 1
Supported Drive
Types and
Cartridges
See Approved Drive Types
Library Robot
Control
LUN
Connectivity Native drive interface
Library Management
− Remote management (web) interface
− Front panel interface
− SNMP protocol