User guide

24 Hardware Installation
11) Slide the unit(s) fully into the rack and fasten them by mounting the ears to the rack
using the two M6x12mm pan-head screws per unit (see Figure 17).
NOTE: mount the screw on the left side before the right side in order to give the correct sideways
orientation of the unit.
12) Connect the unit’s Ethernet cable.
13) Connect Drive cables according to section Installing the Library Cables.
14) Follow the Setup Wizard in the display for setting up the system. You may re-
configure the library at a later stage if necessary. Please refer to Configuring the
Library for more information.
15) Pass-Thru Option: Put the Pass-Thru box into the Pass-Thru magazine (see Figure
18, Figure 19 and Figure 20). Exchange the original T40 LOWER RIGHT MAGAZINE
with the PASS-THRU MAGAZINE (with the Pass-Thru box inserted) and slide it into
the LOWER UNIT’s right lower magazine opening. Re-insert the three other
magazines. Repeat for all units except the upper unit. Re-insert all the original
magazines on the upper unit. The system will now run the inventory sequence and
perform calibration of the unit(s), and it is ready for use. Continue configuring the
library. Please refer to Configuring the Library for more information.
Stand-alone Option: Re-insert all four magazines as-is.
The system will now run the inventory sequence and perform calibration of the unit(s),
and it is ready for use. Continue configuring the library. Please refer to Configuring
the Library for more information.
Caution
You must remove the transport locking screws when powering up the unit
for the first time, or it will not operate.