User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 29
Caution
Remove only the upper blanking plate of the lower-most unit (Master Library), the top
blanking plate of the upper-most unit (Add-On Library) of the combined system. For
units in-between the upper and lower-most unit, remove both blanking plates. Make
sure you do not remove any other blanking plates.
Figure 12. Remove the top blanking plate of the lower-most unit
Figure 13. Remove the bottom blanking plate of the upper-most unit
Note
If the unit is in-between two other units, both top and bottom plates are removed.
Add-
on
Library
bottom
blanking
plate
top
blanking
plate
Master
Library