User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 33
Figure 20. The Complete System
Remove the Transport Locking Screws
To protect the library during transport, four transport locking screws hold the robotics in a locked
position. The screws are marked with red plastic tabs protruding between the magazines and the front
panel.
Caution
The transport locking screws must be removed before the StorageLibrary
can operate normally. Be careful not to drop any of the transport locking
screws inside the unit.
Figure 21. Transport Locking Screws Marked with Red Plastic Tabs
Two StorageLibrary T40+
units in a Pass-Thru Mode.