User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 39
Labeling Cartridges for the Barcode Reader
If you want to use the barcode reader functionality in the library, you must attach barcode labels to the
cartridges.
Note
You need to use StorageLibrary specific bar code labels to ensure reliable
functionality of the barcode reader.
Caution
Cartridge labels must be oriented on the cartridges as shown in the Figure 26.
Other orientations of the cartridge labels may interfere with the loaders
operation.
Cartridge labels must be positioned on the cartridges as shown in Figure 26.The locking mechanism
should be on the left. For more information, see the Working With Cartridges and Barcodes chapter.
Figure 26. Positioning of Barcode Label for LTO Cartridges
If you need more cartridge labels, you can order more labels from your local Tandberg Data sales
representative. Two types of cartridge labels are available. See Figure 27 below for part numbers.
Figure 27. Available Tandberg Data Cartridge Labels.
Figure 27 show the two Tandberg Data specific cartridge labels available. It also show the
corresponding part numbers needed when ordering labels.
For the cleaning cartridges, use the labels starting with prefix CLN. In the right-most image, the
prefix of this type of label is CLNvnnLg, where v identifies a drive unique cleaning cartridge, nn is
used to track individual cleaning cartridge activity (for example usage and life), and g is the LTO
generation.
Label for all LTO cartridges:
Part No. 870222
Labels for LTO3-cartridges: Part No. 1015514
Labels for LTO4-cartridges: Part No. 1017351
In this figure, the
dotted
rectangle
show the correct placement for the cartridge labels.