User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
42 Operator Interfaces
Remote Management Interface (RMI)
The remote management interface (RMI) is similar to the front panel interface (FPI). The remote
management interface is accessible from any supported web browser. For more information on
supported web browsers, please refer to Browser Requirements. To manage the library from a remote
management interface, you must set up the library’s initial network configuration from the front panel
interface. For information on network configuration settings for remote use, please refer to Configuring
Network Settings.
Menu Trees
The following four menus on the FPI and the RMI organize commands into logical groupings:
• The Operations menu consists of commands that enable you to change the library’s mode of
operations, import and export cartridges, load and unload tape drives, eject magazines, clean the
drive and change partition mode.
• The Setup menu consists of commands that you can use to set up and configure various aspects
of the library, including network, Pass-Thru, partitions, I/E stations, cleaning slots, drive
configuration, license, password, menu timeout, date and time, barcode scan, and audible alarm.
• The Reports menu consists of summaries of the values assigned during library setup. It also
includes viewing of RAS tickets and diagnostic logs.
• The Tools menu consists of commands that you can use to maintain your library such as restore
default settings, restore web password, reboot, prepare for shipping, update firmware, and run
system tests.
Figure 28 and Figure 29 give an overview of menus displayed on the FPI and the RMI.