User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 61
• Urgent - The library has failed or is in immediate danger of failing. A resolution must be found
immediately. (This setting enables RAS tickets with priority 1 only.)
Configuring E-mail Notification
Before you can configure e-mail notifications, you must configure the library’s e-mail account so that
the library can send notifications to the designated recipient. E-mail notification can only be configured
from the RMI.
You need to complete the following steps to configure e-mail Event Notification:
1. Enable or disable the e-mail notification feature, as appropriate.
2. Enter the recipient’s e-mail address to be used for event notification. This will be used in the "To:"-
field of e-mail sent by the library.
3. Enter the IP address of the SMTP server (Simple Mail Transport Protocol) the library should use.
This should be an SMTP server that will handle or relay e-mails destined for the domain specified
in the event notification e-mail address. This can be found by looking up the MX record of the
domain in question in DNS.
4. Set Severity Level. Event notification e-mails will not be generated for errors of a severity below
the one chosen.
The screen also provides a method to verify that the chosen settings are valid, by generating a test
notification.
The path to open the appropriate screen is:
• From the RMI, select Setup > Notification