User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 71
8
8 Getting Status and Information
Operator and Administrator can view information about the library by accessing items under the
Reports menu.
The Reports Menu Information is available from both the front panel interface (FPI) and remote
management interface (RMI). We recommend using the RMI to view the reports due to the limited
amount of information it is possible to display on the compact LCD screen on the FPI. Also, the FPI
reports show only a subset of the RMI reports.
The status information listed in this chapter constitutes the reports available from the RMI. For an
overview of the reports available from the FPI, please refer to Figure 28.
Library Settings
The Library Settings Report contains information on the following library settings:
• Inquiry string
• FPI Password - Enabled or Disabled
• Menu Timeout - from 1 to 9
• Barcode Scanner - Enabled or Disabled
• Date and Time - Current date and time
• Audible Alarm - enabled or disabled
• Library Serial Number (Library SN)
• Library Firmware Version (Library FW)
The path to open the library report from the RMI is Reports > Library.
Partition and Drive Information
The Partitions Setting Report is a dynamic representation of the physical locations of various library
resources, including tape drives, magazine slots, partitions, and modules.
The following drive information is available from the Partitions Report:
• Drive Vendor Name <value>
• Drive Product Name <value>