User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
72 Getting Status and Information
• SCSI ID <value as applicable>
• Fibre Channel ID <value as applicable>
• Fibre Topology <value as applicable>
• Fibre Channel Speed <value as applicable>
• SAS Address <value as applicable>
• SAS Port Address <value as applicable>
• Assigned Partition <1, 2, 3, or 4>
• Control Path <Enabled, Disabled>
• Drive Serial Number (Drive SN) <value>
• Drive Firmware Version (Drive FW) <value>
• World-Wide Name
• World-Wide Node Name
The following partition and drive information is available from the Partitions Report:
• Partition Number
• Drive members <Drive ID>
• Magazine members
• Control Path <Yes or No, Drive ID>
• Status <online/offline>
• Total number of storage slots
• Total number of cartridges
• Barcode Reporting Mode <6 Character or 13 Character>
• Auto Clean <Enabled or Disabled>
The path to open the report from the RMI is Reports > Partitions.
Network
The Network Report provides information on the following library settings:
• Basic Network Settings: Address mode (static or dynamic), IP address, subnet mask, gateway,
MAC address.
• Notification Settings: SNMP server, IP address, E-mail address, Notification enabled or disabled,
Severity Level.
• Pass-Thru Settings: Pass-Thru mode, slave library IP address.
The paths to open the appropriate screens are:
• From the RMI, select Reports > Network
• From the FPI, select Menu > Reports > Network