User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 89
RAS
Ticket
Severity
Level
Display Message Description Suggested Action
R0206 High
Drive-n cleaning
failed. Expired
cleaning tape.
The cleaning
operation failed
due to an expired
cleaning tape.
Please remove the expired
cleaning media from the system,
and import a new cleaning media.
To import cleaning media, you
should open the I/E station and
insert one or more cleaning tapes.
The cartridges must be assign to
the Cleaning or System partition.
R0207 High
Cleaning cartridge
in drive-n. Can not
be moved home.
An cleaning
cartridge has
been found in
one of the drives
witch can not be
moved home.
All I/E and cleaning slots are
occupied.
Please remove a tape from the
I/E station, or from the cleaning
slots, or use the Unload Drive
command to move the cleaning
cartridge from the drive.
When a cartridge has been
removed, please reboot the
loader and retry the operation.
R0208 High
Drive-n cleaning
failed. Invalid
cleaning tape.
The cleaning
operation failed
due to an invalid
cleaning tape.
Please remove the invalid
cleaning media from the system,
and import a new cleaning media.
To import cleaning media, you
should open the I/E station and
insert one or more cleaning tapes.
The cartridges must be assign to
the Cleaning or System partition.
R0210 High
Power loss
detected on power
source #1.
Power loss
detected on
power source #1.
Power loss detected on power
source #1.
This failure can be caused by an
AC power loss, the power supply
being turned off, the power cable
not being inserted properly, or a
Power CRU hardware failure.
R0211 High
Power loss
detected on power
source #2
Power loss
detected on
power source #2.
Power loss detected on power
source #2.
This failure can be caused by an
AC power loss, the power supply
being turned off, the power cable
not being inserted properly, or a
Power CRU hardware failure.
R1001 Urgent
Failed moving the
robotics.
The robotics was
not able to move.
Reboot the loader and retry the
operation.
R1100-
R1128
Urgent
Failed to stow at
slot n.
The robotics is
not able to stow
the cartridge to
the magazine
Reboot the loader and retry the
operation.
Remove the magazine if possible.
Remove all cartridges.
Verify that the cartridge is not
damaged.
Insert empty magazines.
Power cycle the loader.
Retry the operation.
Retry the operation with a new
magazine.