User guide
Table Of Contents
- 1 About This Guide
- 2 Product Overview
- 3 Unpacking the StorageLibrary
- 4 Hardware Installation
- 5 Operator Interfaces
- 6 Configuring the Library
- About the Setup Wizard
- Applying a License Key
- Configuring Pass-Thru
- Configuring I/E Slots
- Configuring Cleaning Slots
- Configuring Auto Clean
- Configuring Partitions
- Configuring Menu Timeout
- Setting Date and Time
- Configuring Barcode Scan
- Configuring Audible Alarm
- Configuring Network Settings
- Configuring FPI Password
- Configuring RMI Password
- Configuring SNMP
- Configuring Notifications
- 7 Running the Library
- 8 Getting Status and Information
- 9 Adding, Removing and Replacing
- 10 Updating Firmware
- 11 Working With Cartridges and Barcodes
- 12 Troubleshooting
- 13 Shipping or Transporting the StorageLibrary
- 14 Specifications
- 15 Safety and Regulatory Information
- 16 Approved Drive Types
StorageLibrary T40+ Series Installation and User Guide 93
Interpreting LEDs
LEDs provide a visual indication of the status of certain library components. LEDs can sometimes
communicate that a problem exists when the RAS ticket cannot. For example, a LED can indicate a
firmware problem that prohibits the library from generating RAS tickets.
The following components of the library have LEDs:
• Front Panel
• Ethernet Connector
The Maintenance Menus
Table 5. Maintenance Menus - Item Name and Description
Item name Description
Library FW upgrade Upgrades the library FW through RMI
Prepare to Ship When selected, the robotics is positioned for installing the transport locking
screws.
The magazines are ejected to facilitate the installation.
The library cannot be safely shipped with cartridges in the magazines.
The Prepare to ship command must be run before the library is transported,
in order to re-install the transport locking screws and to remove all cartridges
in the library. The Prepare to ship command is available at the Front Panel
Interface (FPI).
Reboot Performs a hard reset of the library.
Restore default Sets the library settings to their factory default values.
Clear WEB password Clears the WEB password (from FPI only)
The Diagnostics Menu
Table 6. Diagnostics Menu - Item Name and Description
Item name Description
Event log Displays a log that contains information about library and drive configuration,
event log and error log. This log can be saved to a file or sent via e-mail to
technical support.
System test Runs a test of the library hardware.
Cycle test Starts a test where cartridges are moved randomly between magazine slots
and between the drive and the magazines.