Tandberg LTO2 Autoloader Installation and User's Manual

- 68 -
Panel Operation and Other Messages
Table-D7
Table of Panel Operation and Other Messages
Message Description
BUSY
The transporter is operating.
Complete
The executed command has normally completed.
door open
The front door is open.
Dst.full
There is (isn’t) a cartridge in the loading (ejection) destination slot.
err.BCR ini
An error occurred during the initial inventory scan.
FATAL ERR.
The door has been forced open during the transporter operation and the magazine has been
removed.
ILLEGAL MODE
Dip switch settings are not appropriate.
key unlock
The door lock key is unlocked.
no magazine
The magazine is not loaded.
NOT READY
The Autoloader is engaged in the initial operation or an error has occurred.
Not Support
An unsupported command has been received.
open ok
Opening of the door is permitted.
OutOfRange
The Autoloader detected an error during the Y axis operation.
READY
The Autoloader is ready to operate.
REQ CLNROL
Execute cleaning of the Roller.See”Section 5.1.2”
REQ. drv ID
Resetting has been requested because the ID data of the drive in memory is abnormal.
REQ.RESET
Resetting has been requested because the error restoration has been finished.
Reselect
The same ID is set for the loader and drive SCSI ID settings.
SCSI P Err
The Autoloader detected SCSI parity error.
SCSI Reset
The Autoloader detected SCSI reset.
SRC.empty
There is (isn’t) a cartridge in the loading (ejection) destination drive.
S10 forBCR
Remove the cartridge from slot 7. Slot 10 is a free slot for the TD LTO2 Autoloader w/BCR.
wait. .
Waiting for authorization to open the door.