Product manual

APRIL 2007 STORAGELIBRARY T24
137
CLEANING THE TAPE DRIVE
3.
3.3.
3. Press until the selection arrow ( ) points to Clean Drive, and then
press Select.
4.
4.4.
4. Press or to select the “source” slot where the cleaning cartridge is
located (either a slot or the I/E Port), and then press Select.
5.
5.5.
5. Press or to toggle between tape drives (if more than one tape drive is
installed), and then press Select.
6.
6.6.
6. Press OK to clean the tape drive, or Back to cancel the action.
Clean Drive: Source
Slot: n: CLNA02
Select Back
Clean Drive
Destination Drive
01 02
Drive n:
Select Back
Pending Action:
Clean Drive
I/E Port nn Drive nn
OK Back
–+
+–
–+
+–
!
! !
! Important
If there are no more cleaning cycles remaining on the cleaning
cartridge, the tape drive ejects the cartridge immediately without
performing the cleaning. Remove the cleaning cartridge from the
library and use a new one. Do not rewind and reuse the material
in a cleaning cartridge. Reusing the material may redistribute
contaminants previously removed from the tape path.