Network Router - Residential Gateway User Manual

3G Gateway Installation
1
LAN1
LAN2
LAN3
LAN4
2 3
4a 4b 4c
Unpack the 3G Gateway.
Mount the rack ears and/or rubber feet, if
applicable, and turn the unit back on its feet
or mount it in the rack.
connect the 4 PRI connectors … or...
1. Start a Terminal program on the PC and congure it to
115 200, 8, 1, None
2. When prompted for login, enter username admin and
password TANDBERG.
3. Type y to start the installation wizard and press Enter.
4. When prompted, specify a new password, IP settings, lo-
cal prex, SSH y/n, and Telnet y/n.
5. When prompted for login, enter username admin and your
new password.
6. Press Enter to skip the installation wizard.
7. Reboot the system by typing the command xcommand
boot
8. Do the rest of the conguration from the web interface.
Connect the Ethernet LAN cable to socket LAN 1.
Connect the null modem cable between the Data
socket and a PC.
5
… connect the 4 BRI connectors.
6
o
I
o
I
Connect the power cable and turn on the 3G
Gateway. Use the LCD display of the unit to set
the IP address – see Conguring the 3G Gateway
in the User Manual for details, or...
o
I
Start a Terminal program on the PC
and congure it to 115 200, 8, 1, None
LAN1
LAN2
LAN3
LAN4
o
I
LAN1
LAN2
LAN3
LAN4
115196 rev. 02
Depending on version, connect the PRI connector … or...
o
I