Multipoint Control Unit Getting Started Guide

Connecting the MCU

Before you start

Step one: Connect power

Connect the power connector on the rear of the unit to the power supply using the

supplied power cable. (There is no On/Off switch.)

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a

hub, to minimize interference from other devices on the network). The Ethernet

port is a 10/100/1000 Mbps auto-sensing connection

IMPORTANT: Before installing the MCU, you must read the safety

information at http://www.codian.com/safety.htm

Only connect to Ethernet Port B if you need to connect the MCU to a

second subnet.

Do not connect Ethernet Port A and Ethernet Port B to the same subnet.