MPS 200 Installation Unpacking User manual (on CD) Ethernet/LAN cables Power cables Accessories Connecting Cables (front) IP USB1 10/100 BASE T USB0 HOLD ABT RST CPU FAIL COM1 Ethernet Switch D13695.
Connecting Cables (rear) Power cable and power switch at the rear of the MPS 200. SERIAL 3/4 ENET 2 ENET 1 COM 1 KB/MS Power Configuration To do the initial configuration of the IP-address of the System Controller Board and Media Board through the Front Panel, follow the instructions below: 1. Switch on the TANDBERG MPS 200 by pressing the power switch button on the back to ‘1’.