Network Router User Manual

TANDBERG 3G Gateway User Manual

2.2 Connecting cables

Power cable

Connect the system power cable to an electrical distribution socket.

ISDN PRI or BRI cables

The E1/T1 cable should be connected to a CSU (Channel Service Unit). You will need a CSU

between your 3G Gateway and the PRI line from your network provider.

LAN cable

To use the 3G Gateway on IP, connect a LAN cable from the ‘LAN 1’ connector on the 3G

Gateway to your network. The ‘LAN 2, 3 and 4’ connectors are not used and should be left open.

RS 232 cable

To control the 3G Gateway using the dataport, connect an RS 232 cable between the 3G

Gateway’s RS 232 connector and the COM-port on a PC.