Network Router User Manual

TANDBERG 3G Gateway User Manual

To configure the IP number follow the instructions below:

1. Press any key to get the main menu.

2. IP settings should be displayed.

3. Press [ENTER] to access the IP settings menu.

4. Us the [UP/DOWN] key to select IP Address.

5. Press [ENTER] to access the IP address editing menu.

6. Press [ENTER] again to get a cursor.

7. Use up down keys to navigate between the different digits.

8. After selecting a digit use the [ENTER] key in combination with the [UP/DOWN] key to change the

digit value.

9. When finished editing use [ESC] key to go to the confirm change menu.

10. Use the [UP/DOWN] key to select yes or no and [ENTER] to confirm.

11. Use [ESC] key to navigate back to the main menu.

Note that DHCP assigned IP-addresses are supported by the TANDBERG 3G Gateway (factory default),

3G Gateway start-up

To start the 3G Gateway, please make sure that the power cable is connected, and press the

power switch button at the back side to ‘1’.

On the front panel of the system the power indicator LED, marked ‘Pwr’, will turn GREEN.

Accessing the 3G Gateway

You may access the 3G Gateway by entering the IP-address of the 3G Gateway in a standard

WEB-browser. You will then be asked to enter a password. It is not necessary to enter ‘User

Name’. The default password for the 3G Gateway is ‘TANDBERG’. Remember that the password

is case sensitive. Note that it also possible to use SSH and Telnet to configure the 3G Gateway.